性爱小说视频,人人谢人人操,波多野结衣在线观看无码,激情综合激情五月

①注意經常性的校準和檢測

(1) attention to regular calibration and detection

有毒有害氣體檢測儀也同其它的分析檢測儀器一樣 ,都是用相對比較的方法進行測定的 :先用一個零氣體和一個標準濃度的氣體對儀器進行標定 ,得到標準曲線儲存于儀器之中 ,測定時 ,儀器將待測氣體濃度產生的電信號同標準濃度的電信號進行比較 ,計算得到準確的氣體濃度值。因此 ,隨時對儀器進行校零 ,經常性對儀器進行校準都是保證儀器測量準確的必不可少的工作。需要說明的是 :目前很多氣體檢測儀都是可以更換檢測傳感器的 ,但是 ,這并不意味著一個檢測儀可以隨時配用不同的檢測儀探頭。不論何時 ,在更換探頭時除了需要一定的傳感器活化時間外 ,還必須對儀器進行重新校準。另外 ,建議在各類儀器使用之前 ,對儀器用標氣進行響應檢測 ,以保證儀器準確有效。

Toxic and harmful gas detector with other analytical instruments, are determined by the comparative method: after the instrument was calibrated using a zero gas gas and a standard concentration of the standard curve is obtained and stored in the instrument, measurement, electrical instruments will be tested gas concentrations produced the signal with the standard concentration were compared, calculated the exact value of the gas concentration. Therefore, the calibration of the instrument at any time and the regular calibration of the instrument are essential to ensure the accuracy of the instrument. What needs to be explained is that many gas detectors are able to replace detection sensors at present. However, this does not mean that a detector can be equipped with different detectors at any time. Whenever the probe is replaced, it is necessary to recalibrate the instrument in addition to the necessary time for the activation of the sensor. In addition, it is suggested that before the use of all kinds of instruments, the instrument can be tested with the standard gas in response to ensure the accuracy and effectiveness of the instrument.

②注意各種不同傳感器間的檢測干擾

2. Attention to detection interference between different sensors

一般而言 ,每種傳感器都對應一個特定的檢測氣體 ,但任何一種傳感器都不是對的。因此 ,在選擇一種氣體傳感器時 ,都應當盡可能了解其它氣體對該傳感器的檢測干擾 ,以保證它對于特定氣體的準確檢測。

In general, each sensor corresponds to a specific detection gas, but any one of the sensors is not absolutely specific. Therefore, when selecting a gas sensor, we should understand the interference of other gases to the sensor as far as possible, so as to ensure its accurate detection for specific gases.

③注意各類傳感器的壽命

Pay attention to the life of all kinds of sensors

各類氣體傳感器都具有一定的使用年限 ,即壽命。一般來講 ,在便攜式儀器中 ,可燃?xì)鈧鞲衅鞯膲勖^長 ,一般可以使用三年左右 ;光離子化檢測儀的壽命為四年或更長一些 ;電化學特定氣體傳感器的壽命相對短一些 ,一般在一年到兩年 ;氧氣傳感器的壽命比較短 ,大概在一年左右(電化學傳感器的壽命取決于其中電解液的干涸 ,所以如果長時間不用 ,將其密封放在較低溫度的環境中可以延長一定的使用壽命) 。固定式儀器由于體積相對較大 ,傳感器的壽命也較長一些。因此 ,要盡可能在傳感器的有效期內使用 ,一旦失效 ,及時更換。

All kinds of gas sensors have a certain service life, that is, life. Generally speaking, the portable instrument, a long life of gas sensors, can generally be used for about three years; photoionization detector for a lifetime of four years or longer; specific electrochemical gas sensor life is relatively short, usually in one to two years; the oxygen sensor has the shortest life, probably in about a year (life depends on the electrochemical sensor in which the electrolyte dries up, so if not used for a long time, the sealing in low temperature environment can prolong the service life of certain). Because of the relatively large volume of the fixed instrument, the life of the sensor is longer. Therefore, it should be used as much as possible in the validity period of the sensor, and if it fails, it should be replaced in time.

④注意檢測儀器的濃度測量范圍

(4) pay attention to the measuring range of the concentration of the instrument

各類有毒有害氣體檢測器都有其固定的檢測范圍。只有在其測定范圍內完成測量 ,才能保證儀器準確地進行測定。而長時間超出測定范圍進行測量 ,就可能對傳感器造成性的破壞。

All kinds of toxic and harmful gas detectors have their fixed detection range. The accurate measurement of the instrument can be ensured only if the measurement is completed within the range of its measurement. It is possible to cause permanent damage to the sensor by measuring the range beyond the measurement for a long time.

比如 , 可燃?xì)怏w檢測儀器 , 如果不慎在超過100 %LEL 的環境中使用 ,就有可能徹底燒毀傳感器。而有毒氣體檢測器 ,長時間工作在較高濃度下使用也會造成損壞。所以 ,固定式儀器在使用時如果發出超限信號 ,要立即關閉測量電路 ,以保證傳感器的安全?？傊?,有毒有害氣體檢測儀是保證工業安全和工作人員健康的有力工具。我們要根據具體的使用環境場合以及需要的功能 ,選擇合適的氣體檢測儀。目前 ,可供我們選擇的檢測儀包括固定式/便攜式、擴散式/泵吸式、單氣體/多氣體、無機氣體/有機氣體等多種多樣的組合。只有選擇好了合適的氣體檢測儀器 ,才能真正做到事半功倍，防范于未然。

For example, a flammable gas detector, if used inadvertently in an environment exceeding 100%LEL, could completely burn up the sensor.  And the toxic gas detector, for a long time working at a higher concentration, can also cause damage. In order to ensure the safety of the sensor, the measuring circuit should be shut down immediately when the fixed instrument is used. In a word, the toxic and harmful gas detector is a powerful tool to ensure the safety of industry and the health of the workers.  We should choose the appropriate gas detector according to the specific environment and the functions needed. At present, the detectors we can choose include fixed / portable, diffuser / pump suction, single gas / multi gas, inorganic gas / organic gas and so on. Only by choosing the right instrument of gas detection can we get twice the result with half the effort and prevent it.