新聞中心
制果機械用旋渦氣泵使用問題：
The use of whirlpool pump for fruit machinery:
當出現壓力和流量下降時，切斷旋渦氣泵的電源，查看進氣口是否有東西堵塞，檢查進氣口過濾網，不過不要拆除過濾網，否則會把雜物吸進氣泵，導致?lián)p壞。其次，若發現機器內部有雜物的，導致橡膠皮頂住了電流造成電磁不能恢復位置。
When pressure and flow rate decrease, first cut off the power supply of the vortex air pump, check whether there is something clogging in the intake port, check the inlet filter net, but do not dismantle the filter screen, otherwise, you will suck the sundries into the air pump and cause damage. Secondly, if it is found that the inside of the machine has sundries, it causes the rubber skin to withstand the current and cause the electromagnetic non recovery position.
噪音過大影響正常工作應檢查旋渦氣泵泵體內是否有雜物，如有，則打開外殼，清理內部雜物；其次檢查葉輪是否卡住，此時建議聯系廠家修理，需要重新裝配才能消除故障。第三檢查軸承是否損壞，必要時更換部件。
If the noise is too large, the normal work should check whether there is any debris in the vortex pump. If it is, then open the case and clean up the internal impurities. Secondly, check whether the impeller is stuck. At this time, it is best to contact the manufacturer for repair, and then need to reassemble to remove the trouble. Third check whether the bearing is damaged or replacement parts when necessary.
溫度過高將會導致旋渦氣泵不能正常運行檢查進氣口是否堵塞，清洗進氣口過濾網，但不能拆除，否則將會吸進雜物損壞氣泵絲印及照排機及其它需要吸力的機械設備。請適當保持氣泵的工作時間隙。其次檢查機體內有雜物，打開外殼，清理內部雜物。
The high temperature will cause the vortex air pump to not operate normally, check whether the intake port is blocked or not, clean the intake filter net, but it cannot be removed, otherwise, it will suck into the debris, damage the air pump, screen printing and phototypesetting machine and other mechanical equipment that needs suction. Please keep the working time gap of the pump properly. Second, check the body in the body, open the outer shell, clean up the internal debris.
制果機械用旋渦氣泵的使用保養：
The use and maintenance of the whirlpool pump for fruit making machinery:
1、定期檢查旋渦氣泵部件。
1. Check the components of the vortex gas pump regularly.
2、在工作中遇到問題及時請專業人員進行檢查忽操作。
2, in the work encountered problems in time to ask professional personnel to check the operation.
3、更換損壞的部件，不應部件損壞而照常工作。
3, replace the damaged parts, should not work as usual, and should not be damaged.
4、在工作中按照正確的方法操作。
4, operate in the right way in the work.
5、保養要有一定周期性。
5, maintenance should have certain periodicity.
