性爱小说视频,人人谢人人操,波多野结衣在线观看无码,激情综合激情五月

溫控器液晶面板為專用定制面板，由風機盤管廠家直接配套提供，不能直接到市場購買。

The thermostat liquid crystal panel is a special custom panel, which is provided directly by the fan coil manufacturer, and can not be purchased directly to the market.

緣循智能科技（上海）有限公司技術部和大家分享下直流無刷風機盤管的安裝接線方法。

The Technology Department of the intelligent technology (Shanghai) Co., Ltd. shares the installation and wiring method of the DC brushless fan coil.

1、打開盤管接線盒，如上圖1，用兩芯線纜，一頭接到“去溫控器面板”兩接線柱，線纜的另一頭接到溫控器液晶面板（如下圖2）后面的兩接線柱（不分正反）。

1, open the coil terminal box. For example, figure 1, with two core cable, one end is connected to the two terminal post of the temperature controller panel. The other end of the cable is connected to the two post post of the Thermostat LCD panel (as shown below 2).

2、打開盤管接線盒，如上圖1，將電源線接到盤管接線盒內“電源線”兩個接線柱上。

2, open the coil junction box, as in Figure 1, the power line is connected to the two terminals of the "power line" inside the coil box.

3、如需接電磁閥，打開盤管接線盒，如上圖1，將電磁閥兩根線接到接線盒內“電磁閥”兩個接線柱上。

3, if you need to connect the solenoid valve, open the coil junction box, as in Figure 1, the two wires of the solenoid valve are connected to the "solenoid valve" of the two terminals in the junction box.

確認接線無誤后，接通電源，即可正常運行，如風量太大或太小需調整，可通過溫控器液晶面板進行重新設定3檔風量。

After confirming that the wiring is correct, the power is switched on, and it can run normally. If the wind volume is too large or too small, it needs to be adjusted. It can reset the 3 air volume through the LCD panel of the thermostat.